邛崃Safety operating procedures for desktop drilling machines

Today, the editor of a desktop drilling machine will take you to understand the safety operation process of a desktop drilling machine. The main purpose of this explanation is to specify the safety requirements for the operation of a desktop drilling machine, ensuring the personal safety of personnel and the safe operation of equipment.

After understanding the purpose of this explanation, let's now talk about the safety operating procedures of desktop drilling machines:

1. Before use, it is necessary to check whether all components of the drilling machine are normal. Work clothes must be worn, cuffs must be tied, scarves are not allowed, gloves are strictly prohibited, and female hair braids should be tied inside hats.

2. The platform of the drilling machine needs to be tightly secured, and the workpiece needs to be clamped. When drilling small pieces, special tools should be used to hold them, and it is not allowed to hold or press the drill with your hands to avoid accidents caused by the rotation of the drill bit, such as injury to people and equipment damage.

3. When adjusting the drilling machine speed, clamping tools and workpieces, and when wiping the drilling machine, it is necessary to stop the machine.

4. When the drill bit is wrapped with long debris, it should be stopped to remove it. It is prohibited to blow or pull with your mouth, and a brush or iron hook should be used to remove it.

5. If any abnormal situation is found, the vehicle should be stopped immediately and relevant personnel should be checked.

6. When the drilling machine is in operation, it is not allowed to leave the work position. If you need to leave for some reason, you must stop and cut off the power.

7. When drilling thin plates, a wooden board should be added as a cushion. When the drill bit is about to penetrate the workpiece, light pressure should be applied to avoid breaking the drill bit, damaging the equipment, or causing accidents.

8. When the drill bit is in operation, it is prohibited to use cotton yarn and towels to wipe the drilling machine and remove iron filings. After work, the drilling machine must be wiped clean, the power supply must be cut off, and the parts stacking and work site must be kept neat and tidy.